Aluminum anodizing DC rectifier used in anodic oxidation of aluminum, this technical process is actually a process by mean of electrolytic aluminum surface to make aluminum profile or aluminum alloy profile forming alumina oxidization film. Our rectifiers also have imitation gold electroplating power supply, pulse electroplating rectifiers, high-frequency electro plating power supply, DC voltage stabilization power supply, battery charging power supply, DC motor test power supply, experimental measurement power supply, pulse superposition hard oxidation DC rectifier, special usage silicon AC to DC rectifier, electric furnace heating power supply, high power (electrolysis, oxidation) power supply and some matched power supply equipment etc..
anodising dc rectifier
Aluminum anodizing DC rectifier usage:
Aluminum anodizing DC rectifiers applied to aluminum profile (aluminum and aluminum alloy and so on) anodic oxidation treatment.
Aluminum anodizing DC rectifier features:
Has the advantages of small volume, light weight, high efficiency, high control precision, etc..;
Pulse width modulation power introduced international advanced technology, using IGBT power module of the international brand;
Complete protection function, has voltage stabilization & current stabilization working mode, and filtration, over-voltage, overheating, short circuit, phase missing protection functions and soft start.
The power supply adopts special design control system, internal structure of anti acid, anti alkali design, which greatly increase the service life of the product.
We can provide:
a. Digital timing system;
b. Ampere hour meter;
c. Standard interface;
d. Control signal interface.
Aluminum anodizing DC rectifier technical parameters:
Input voltage: three-phase four wire 380V, 415V, 50-60Hz;
DC output current: 100A-30000A can be optional;
Output DC voltage: 3V-1000V arbitrary choice;
Voltage stabilization accuracy: less than or equal to 1%;
Current stabilizing precision: less than or equal to 1%;
The output ripple current: 1%-2%;
Cooling method: forced air cooling or water cooling;
The cooling water quality: ordinary tap water, deionized water (recommended); PH value: 7-8, Water pressure: 0.1-0.25MP, Temperature: 3 degrees -33 degrees;
Load operation: full load run for 24 hours, more than 1000 meters above sea level, reducing the use of capacity;
Working environment: the environment temperature is 10 degrees below zero to 40 degrees; at room temperature (15-25 degrees) of air relative humidity should be less than 90%.
If need better hardness and quality, pulse power supply is good for your choice.The packing of rectifier and services:
This section aluminum oxidation power supply using standard packaging (for details, please refer to our products packaging instructions).
